Sens'it is a device with 5 sensors that communicates with the Sigfox network.
Before starting...
Sigfox back-end configuration
The device automatically communicates with the Sigfox network after it is turned on. It is required to configure the Sigfox back-end so the device is detected.
Once the device type and the device corresponding to the Sens'it device have been created, you need to set the callbacks up correctly to start transmission.
Configuration completed!
Once the procedure has been completed, Databoom starts to record data from the Sens'it. To examine your data and have a correct representation, follow the instructions in Edit/validation of a signal.
0 Comments